Help - BT 90 User Manual

Help

Freestyle 90, this section will give you the most common,
easy-to-follow solutions.
Telephone problems
• No dialling tone.
• Telephone will not dial out.
• Telephone cannot receive
calls.
• Beeps six times and drops
calls.
• You have a dialling tone but
the telephone will not dial
out.
• Handset does not ring.
• No lights on handset.
• Handset does not ring, but
lights show on the handset.
22
If you have any problems using your
Possible cause
Telephone not connected to
telephone line.
Mains disconnected and back-up
battery is not installed or is flat.
Power cut and back-up battery is
not installed or is flat.
Handset battery is discharged.
You may be trying to use tone
dialling on a pulse dialling
exchange.
You are connected to a PBX and are
not dialling the access code.
Handset battery is discharged.
The handset ringer may be set to its
minimum setting.
Solution
Replace the handset on the base unit
for 10 seconds and try again. If this
does not work, disconnect the
handset battery from the handset for
10 minutes. Also disconnect the
mains power and back-up battery.
Then reconnect the battery and
reconnect the base unit to the mains,
then replace the handset on the base
unit for 10 seconds and try again.
Plug the telephone into the
telephone line.
Reconnect and install or replace
the back-up battery.
Wait until the power is restored and
install or replace the back-up battery.
Place the handset on the base unit
and recharge it for 24 hours
ensuring the
CHARGING
Set the mode switch to
dialling).
Use the PBX access code.
Place the handset on the base unit
and recharge it for 24 hours.
Increase the handset ringer volume.
light is on.
(pulse
P-E