Setting The Handset - BT 90 User Manual

Freestyle 90/130/1200 Additional Handsets
To erase a registration code
• Press the
QUICKDIAL
• Press the
CHANNEL SEEKER
button.
• Press the button four times.
• Press the
QUICKDIAL
You will hear a confirmation
beep, the old registration code is
now erased and you can re-
register your additional handset
following the procedure above.
To re-register an additional
handset
If necessary you can re-register
your additional handset by simply
following the steps described in 'To
register an additional handset'on
the previous page.
Before re-registering the old
registration code must first be erased.
To check that your additional
handset is registered correctly
Lift the additional handset.
•
Press the
• TALK
Listen for the dial tone.
•
If you do not hear a dial tone, your
additional handset is either out of
range of your Freestyle 90, the
Freestyle 90 phone line cord is not
plugged in, it has not been
registered properly or you may
have purchased the wrong
20
button.
button.
button.
handset - check that the handset
you have is item code: 871267.
This can be found on the side of
your giftbox.

Setting the handset

number
Each additional handset must be
assigned an identity number (1, 2, 3
or 4). Your Freestyle 90 handset is
already numbered as
additional handsets can then be
numbered as they are added.
Your Freestyle additional handset is
pre-set to handset number 2.
To set a handset identity number
• Press and release the
button.
QUICKDIAL
• Press and release the
button.
• Enter the identification number
(1-4) using the keypad.
• When you have entered the
number press the
button.
• You will hear a beep confirming
that the new number has been
stored.
Make a note of the identification
number by writing it on the handset's
directory label.
,
HANDSET 1
SECRECY
QUICKDIAL