Table of Contents
Advertisement
Installation
To install:
1. Unscrew the exhaust extension, shipped with the standard pump.
This step is only for pumps with the extension mounted on the pump. If exhaust
extension is not mounted, go to step 2.
2. Screw the hose barb fitting into exhaust fitting underneath the pump:
❑
½" hose x ¼" NPT for TS300
❑
½" hose x 3/8" NPT for TS600
Refer to Figure 2 for reference on barb-to-hose insertions.
3. Cut the Tygon tubing in two pieces. Suggested lengths are: 7¼" and 4¾".
4. Connect the longer piece of Tygon tubing into (Figure 1 on page 9):
a. The ½" hose end of the 3/8" NPT barb, coming from underneath the pump and
b. Connect the silencer/resonator chamber equipped with the ½" hose end 3/8"
Refer to Figure 1 for reference on hose connections.
5. Connect the shorter piece of Tygon tubing by (Figure 1 on page 9):
a. Connecting the resonator using the another ½" hose on the silencer/resonator
b. Attaching the reducer coupling to the muffler-filter and then the ¾" NPT x ½"
c. Connecting the muffler-filter to the 2nd piece of Tygon tubing and secure with a
TriScroll Exhaust Silencer Kit
NOTE
To ensure proper operation, and to prevent damage, the kit
must be installed and operated only as specified.
secure it with a hose clamp.
NPT barb to the other side of the longer Tygon tubing and secure with a hose
clamp.
and secure with a hose clamp.
hose barb fitting to the coupling.
hose clamp.
8
Advertisement
Table of Contents
