VTech VM341-2 Quick Start Manual

Go to www.vtechphones.com VM341-2
to register your product for
enhanced warranty support
and latest VTech product news.
Quick start guide
Connect and power on - Baby unit
Change different views - View
Press VIEW to switch between the image of baby units and .
Press VIEW
What's in the box
Install the battery
>
More than 1 meter 1m (3ft)
(3 feet)
THIS SIDE UP
Change different views - Patrol
Press PATROL to alternately view the image from baby units and every 10 seconds.
10s
VM341-2 baby monitor system
Baby's room
Connect and power on - Parent unit
2s
>
1m (3ft)
CAUTION
• The default volume of your parent unit
is level 4. If you experience high-pitched
screeching noise from your baby monitor
while positioning:
<
- Make sure your baby units and parent unit
1m (3ft)
are more than 1 meter (3 feet) apart, OR
- Turn down the volume of your parent unit.
Change different views - Split
Press SPLIT to view the images from all baby units at once.
Living room
Status check
Once you power on your baby monitor, your parent unit displays image from baby unit , and the LINK LED
light turns on.
The ON/OFF LED light of baby unit turns on. As baby unit is not being viewed, its ON/OFF LED light flashes.
Dim mode
With dim mode preset to on, your parent unit display will dim after 10 minutes of inactivity to conserve energy.
10 min inactivity
Press any buttons