Console Setup Mode - Nautilus T626 Assembly Manual / Owner's Manual

The Console Setup Mode lets you control the sound settings ( on/off ), adjust the date and time, or see maintenance
statistics (Total Run Hours and Software Version– for service technician use only).
1. Hold down the PAUSE/STOP button and Right button together for 3 seconds while in the Power-Up Mode to go into
the Console Setup Mode.
Note: Push PAUSE/STOP to exit the Console Setup Mode and return to the Power-Up Mode screen.
2. The Console display shows the Date prompt with the current setting. To change, push the Increase/Decrease buttons
to adjust the currently active value (flashing). Push the Left/Right buttons to change which segment is the currently
active value (month / day / year).
3. Push OK to set.
4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust
the currently active value (flashing). Push the Left/Right buttons to change which segment is the currently active value
(AM or PM / hour / minute ).
5. Push OK to set.
6. The Console display shows the UNITS prompt with the current setting. Push the Increase/Decrease buttons to
change between "MILES" and "KM".
7. Push OK to set.
8. T he Console display shows the Sound Settings prompt with the current setting. Push the Increase/Decrease buttons
to change between "ON" and "OFF".
If the Sound has been muted, the Console will display the "AUDIO OFF" prompt before a Workout starts as
a reminder.
9. Push OK to set.
10. The Console display shows the TOTAL RUN HOURS for the machine.
11. For the next prompt, push the OK button.
12. The Console display shows the BLE FW UPDATE prompt.
Note: If you have an update for the Bluetooth® Low Energy (also called Bluetooth® Smart) system, insert the USB
Flash Drive with the update file into the Console. Push the Increase/Decrease buttons to select the "CONFIRM-YES"
option, and push OK.
The Console will display "SAVING", and then "REMOVE USB" when it is safe to remove the USB Flash Drive.
13. F or the next prompt, push the OK button.
14. The Console display shows the Software Version code.
15. For the next prompt, push the OK button.
16. The Console display shows the LOG prompt.
17. For the next prompt, push the OK button.
18. T he Console will display the Power-Up Mode screen.

CONSOLE SETUP MODE

45