Before Starting To Use The Water/Ice; Dispenser; Transportation Of The Product - Beko ASN541B User Manual

Installation
3.13. Before starting
to use the water/
ice dispenser
(This feature is optional)
• If the water pressure is below 1 bar
then a separate pump may need to be
used.
• Water system of the refrigerator must
be connected to the cold water line. It
must not be connected to hot water
line.
• No water may be obtained in the
initial start-up of the refrigerator.
Because there is air in the system. To
discharge air from the system, press
dispenser latch for 1-2 minutes until
water comes from the dispenser.
Water flow may be irregular at the
beginning. After the air in the system
is discharged, water flow will return
to normal.
• During initial use, you will have to
wait approximately 12 hours for the
water to cool down.
• It will take around 1-2 days for the
system to produce the full amount of
ice.
• Water pressure must be between 1-8
bars for the operation of ice/water
dispenser smoothly. For this, check
that 1 glass of water (100 cc) can be
filled in 10 seconds.
• The first 10 glasses of water should
not be consumed.
• You must wait approximately 12
hours to obtain ice from the ice
dispenser for the first time. If there
is not enough ice in the ice container,
ice may not be obtained from ice

dispenser.

• Do not consume the first 30 pieces
(3-4 Liters) of ice cubes.
• First several glasses of water may be
cloudy when the filter is used for the
first time. Therefore, do not consume
the first several glasses of water.
• If the water dispenser is not used for
a long period of time, first 1-2 glasses
of water can be not so cold.
• If a power outage or a temporary
failure occurs while the refrigerator
is operating, ice can melt down a
little bit and then get frozen again.
In such a case, ice cubes can stick to
each other. If the outage or failure
prolongs, ice can melt down causing
water leakage. If you experience such
a problem, empty and clean the ice
container.
• Ice cubes can stick to each other if
they are left in the container for a
long time.
• If the product is to be connected to
the water mains, make sure that you
use potable water.
• Water system of the product is
designed to operate only with water.
Do not use beverage such as soft
drinks and/or juices in the water
system.
• It is recommended that the water is
disconnected if you will not be using
the refrigerator for a long period
of time due to vacation or similar
reasons.
• Do not attempt to dismantle the ice
container group assembly parts.
• Do not attempt to clean the ice
container assembly without removing
it from the refrigerator.
3.14. Transportation
of the product
1. Unplug the product before transporting
it.
2. Remove water connections.
3. Secure the shelves, accessories, crisper
and etc. in the refrigerator by adhesive
tape before repackaging it.
C
Packaging must be adequate and
the rules of transportation printed
on the package must be followed.
14 / 41 EN
Refrigerator / User Manual