Activating Water Filter Change Warning; Before Starting To Use The Water/Ice; Dispenser - Beko ASN541B Manual

Installation
3.12. Activating water
filter change warning
ASP341 models only
(For products connected to the mains water line
and equipped with filter)
Water filter change warning is activated as follows:
1. Within 60 seconds after switching on the
refrigerator, press and hold the Display and
Vacation buttons for 3 seconds.
2. Then enter 1-4-5-3 as password.
Confirming the entered
password
4
3
4
3
Enter 1-4-5-3 as follows:
Press FF set button for once.
Press FRZ set button for once.
Press FF set button for 4 times.
Press FRZ set button for once.
Press FF set button for 5 times.
Press FRZ set button for once.
Press FF set button for 3 times.
Press FRZ set button for once.
A
A
Selecting the
password numbers
2
2
1
1
12 / 31 EN
If the password is entered correctly, buzzer will sound
shortly and Filter Change Warning indicator will turn on.
Automatic filter usage time calculation is not enabled
ex factory.
It must be enabled in products equipped with a filter.
The refrigerator will give filter change warning with
6-month intervals automatically.
If the same procedure is repeated when the automatic
filter usage time calculation is enabled, then the
function will be canceled.
3.13. Before starting to use
the water/ice dispenser
(This feature is optional)
• If the water pressure is below 1 bar then a
separate pump may need to be used.
• Water system of the refrigerator must be
connected to the cold water line. It must not be
connected to hot water line.
• No water may be obtained in the initial start-
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
• During initial use, you will have to wait
approximately 12 hours for the water to cool
down.
• It will take around 1-2 days for the system to
produce the full amount of ice.
• Water pressure must be between 1-8 bars for
the operation of ice/water dispenser smoothly.
For this, check that 1 glass of water (100 cc)
can be filled in 10 seconds.
• The first 10 glasses of water should not be
consumed.
• You must wait approximately 12 hours to
obtain ice from the ice dispenser for the first
time. If there is not enough ice in the ice
container, ice may not be obtained from ice

dispenser.

Refrigerator / User Manual