Table of Contents
Advertisement
SmartNode 4170 User Manual
Installing cables
WARNING
WARNING
Connect the cables in the following order:
1. Connect the ISDN PBX and NT to the PRI port (see section
SmartNode's ISDN PRI
2. Connect the 10/100/1000Base-T Ethernet Port (see section
net
cable")
3. Connect the power mains cable (see
Connecting ISDN PBX and NT to the SmartNode's ISDN PRI port
The SmartNode comes with one ISDN PRI (E1/T1) port located on the rear panel (see figure 2 on page 16).
The port can be connected to the PSTN (ISDN NT) or to a PBX (ISDN TE). Please check the cabling and
port pinout first, before connecting the SmartNode ISDN port. See Appendix C,
CAUTION
For details on the PRI port pinout and ISDN cables, refer to
D, "Port pin-outs"
on page
Connecting the 10/100/1000Base-T Ethernet cable
The SmartNode 4170 has automatic MDX (auto-cross-over) detection and configuration on the Ethernet port.
The port can be connected to a host or hub/switch with a straight-through wired cable.
•
Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
For details on the Ethernet port pinout and cables, refer to
D, "Port pin-outs"
on page 45.
Installing the Patton SmartNode VoIP Gateway
Do not work on the system or connect or disconnect
cables during periods of lightning activity.
The Interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
port")
section"Connecting the Power Supply"
For the ISDN connection to a carrier Network, it shall be con-
nected to a Network Termination Device and not connected
directly to an outside POTS line.
45.
"Connecting ISDN PBX and NT to the
"Connecting the 10/100/1000Base-T Ether-
on page 25)
"Cabling"
Appendix C, "Cabling"
Appendix C, "Cabling"
3 • SmartNode Installation
on page 41
on page 41 and
Appendix
on page 41 and
Appendix
24
Advertisement
Table of Contents
