Static Router Ports Entry - D-Link DGS-3024 User Manual

The following parameters may be viewed or modified:
Parameter
VLAN ID
VLAN Name
Query Interval
Max Response Time
Robustness Value
Last Member Query
Interval
Host Timeout
Route Timeout
Leave Timer
Querier State
State
Click Apply to implement the new settings. Click the
Snooping Group Entries window.

Static Router Ports Entry

DGS-3024 Gigabit Ethernet Switch Manual
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
Allows the entry of a value between 1 and 65535 seconds, with a default of 125
seconds. This specifies the length of time between sending IGMP queries.
Sets the maximum amount of time allowed before sending an IGMP response report.
A value between 1 and 25 seconds can be entered, with a default of 10 seconds.
A tuning variable to allow for subnetworks that are expected to lose a large number of
packets. A value between 2 and 255 can be entered, with larger values being
specified for subnetworks that are expected to lose larger numbers of packets. The
default is 2 seconds.
Specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. A value between 1 and 25.
The default is 1 second.
This is the maximum amount of time in seconds allowed for a host to continue
membership in a multicast group without the Switch receiving a host membership
report. The default is 260.
This is the maximum amount of time in seconds a route is kept in the forwarding table
without receiving a membership report. The default is 260.
This specifies the maximum amount of time in seconds between the Switch receiving
a leave group message from a host, and the Switch issuing a group membership
query. If no response to the membership query is received before the Leave Timer
expires, the (multicast) forwarding entry for that host is deleted.
Choose Enabled to enable transmitting IGMP Query packets or Disabled to disable.
The default is Disabled.
This field can be toggled between Enabled and Disabled and enables or disables
IGMP for the VLAN. The default is Disabled.
Figure 6- 8. Current Static Router Ports Entries window
Show All IGMP Group Entries
22
link to return to the Current IGMP