Link Aggregation Commands - D-Link DGS-3024 Command Line Interface Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation
delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
DGS-3024:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3024:4#
delete link_aggregation group_id
Purpose
Syntax
Description
Parameters
DGS-3024 Layer 2 Switch CLI Reference Manual
Parameters
group_id <value 1-4>
group_id <value 1-4>
group_id <value 1-4> {master_port <port> | ports <portlist> | state
[enable | disable]}
[mac_source | mac_destination | mac_source_dest]
{group_id <value 1-4> | algorithm}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-4>
This command will create a link aggregation group with a unique identifier.
<value 1-4> − Specifies the group ID. The Switch allows up to 4 link
aggregation groups to be configured. The group number identifies each of
the groups.
Only administrator-level users can issue this command.
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-4>
This command is used to delete a previously configured link aggregation
group.
<value 1-4> − Specifies the group ID. The Switch allows up to 4 link
i b
L A
INK GGREGATION
fi d Th
95
16
C
OMMANDS
b id ifi h f