D-Link DGS-3024 Command Line Interface Reference Manual page 117

config radius add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure RADIUS server communication settings:
DGS-3024 Layer 2 Switch CLI Reference Manual
DGS-3024:4#config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DGS-3024:4#
Used to configure the settings the Switch will use to communicate with a
RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
The config radius add command is used to configure the settings the
Switch will use to communicate with a RADIUS server.
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
<passwd 32> − The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
default − Returns all of the ports in the range to their default RADIUS
settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Only administrator-level users can issue this command.
DGS-3024:4#config radius add 1 10.48.74.121 key tomato default
Command: config radius add 1 10.48.74.121 key tomato default
Success.
DGS-3024:4#
115