D-Link DES-3550 Command Line Interface Reference Manual page 29

DES-3550:4#reboot
Command: reboot
Are you sure want to proceed with the system reboot? (y|n)
Please wait, the switch is rebooting...
reset
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To restore all of the Switch's parameters to their default values:
login
Purpose
Syntax
Description
DES-3550 Layer 2 Fast Ethernet Switch
Used to reset the Switch to the factory default settings.
reset {[config | system]}
This command is used to restore the Switch's configuration to the
default settings assigned from the factory.
config − If the keyword 'config' is specified, all of the factory default
settings are restored on the Switch including the IP address, user
accounts, and the switch history log. The Switch will not save or
reboot.
system − If the keyword 'system' is specified all of the factory default
settings are restored on the Switch. The Switch will save and reboot
after the settings are changed to default. Rebooting will clear all
entries in the Forwarding Data Base.
If no parameter is specified, the Switch's current IP address, user
accounts, and the switch history log are not changed. All other
parameters are restored to the factory default settings. The Switch
will not save or reboot.
Only administrator-level users can issue this command.
DES-3550:4#reset config
Command: reset config
Are you sure to proceed with system reset?(y/n)
Success.
DES-3550:4#
Used to log in a user to the Switch's console.
login
This command is used to initiate the login procedure. The user will be
prompted for a Username and Password.
21