D-Link DES-3550 Command Line Interface Reference Manual page 205

config authen server_host
Restrictions
Example usage:
To configure a TACACS+ authentication server host, with port number 4321, a timeout value of 12 seconds and a
retransmit count of 4.
DES-3550:4#config authen server_host 10.1.1.121 protocol tacacs+
port 4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs+ port
4321 timeout 12 retransmit 4
Success.
DES-3550:4#
delete authen server_host
Purpose
Syntax
Description
Parameters
DES-3550 Layer 2 Fast Ethernet Switch
timeout <int 1-255> - Enter the time in seconds the Switch will wait
for the server host to reply to an authentication request. The default
value is 5 seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to
change how many times the device will resend an authentication
request when the server does not respond. This field is inoperable
for the TACACS+ protocol.
Only administrator-level users can issue this command.
Used to delete a user-defined authentication server host.
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
This command is used to delete a user-defined authentication
server host previously created on the Switch.
server_host <ipaddr> - The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes
the TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
197