Table of Contents
Advertisement
INSTALLATION/CONNECTION
Part list for installation
(A) Wiring harness
(B) Flat head screw M5 × 8 mm (M5 × 3/8")
(C) Round head screw M5 × 8 mm (M5 × 3/8")
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 39)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the
terminal of the car battery.
5 Press
to turn on the power.
6 Reset the unit. ( 3)
38
ENGLISH
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws (B) or (C). The screw holes differ depending on the model
of the cars.
Do the required wiring. ( 39)
Dashboard of your car
Use only the specified screws. Using wrong screws might damage
the unit.
Car bracket
Hide quick links:
Advertisement
Table of Contents
