Hardware Installation - D-Link SECURICAM Network DCS-5300W Manual

Hardware Installation

Connect to an Ethernet Network
If you are connecting the DCS-5300W to a
wired Ethernet network, connect an
Ethernet cable to the Ethernet connector
located on the Internet Camera's back
panel and attach it to the network.
If you are connecting the DCS-5300W to a
802.11b wireless Ethernet network, attach
the two wireless antennas to the antenna
connectors on the back panel of the DCS-
5300W.
Attach the external power supply
Attach the external power supply to the DC
power input connector located on the
Internet Camera's back panel (labeled 12V
1.5A) and connect it to your wall outlet.
When you have a proper connection, the LED will turn from
light may cycle on and off and your computer may show an intermittent loss of
connectivity, this is normal until you have configured your Internet Camera.
Attaching the Internet Camera to the Camera Stand
The Internet Camera comes with a camera
stand with a swivel ball screw head that
can be attached to the Internet Camera
bottom socket cavity. Attach the camera
stand to the Internet Camera and station it
for your application. There are holes
located in the base of the camera stand,
which allow the Internet Camera to be
securely mounted to the ceiling, or any wall.
9
red to green. The