Hardware Installation - D-Link DCS-6620 Install Manual

DCS-6620 Install Guide
Connect the Ethernet Cable
Connect one end of the Ethernet cable to the network cable connector located on
the back panel of the DCS-6620, and attach the other end to a router, switch, or
gateway on the network.
If you connect this camera
directly to a PC, you will
need a cross-over Ethernet cable.
If you plug the camera into a hub
or router, you will be able to use the
cable included with your camera.
Attach the External Power Supply
Attach the external power supply to the DC
power input connector located on the PTZ
Internet Camera's backpanel (labeled 12V) and
connect it to an AC power outlet.
Power source is confirmed when
the LED Power Indicator on the
PTZ Internet Camera is illuminated.
Both the red and green LEDs will flash alternately and only the red LED will remain
lit. The green LED will not come on until you have configured your camera.
D-Link Systems, Inc.

Hardware Installation

5