Directions For Use - Guardian H3250 Use & Care Instructions Manual

DIRECTIONS FOR USE

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
NOTE: Handle is designed to carry tank, not unit.
FILLING
Make sure unit is unplugged.
LID A
1. Lift the water tank by the handle
to separate the tank from the base
of the unit.
3. Pour cool, clean water directly into the tank. Do not pour anything but water into the tank.
Close the tank lid, turning it to the right. It is important to FIRMLY secure cap after filling the tank with water.
4. Return the tank.
A. Guide tank into base.
B. Lift tank slightly to connect
tank to the top edge of the
control panel.
A B
E-6
LID B
2. Depending on your water source choose
either tank LID A (fill sideways) or
tank LID B (fill lengthwise).
Remove lid by turning it to the left.
IMPORTANT: Remove only 1 lid when filling.
5. Add a few drops of your favorite essential
oil to the pad in the tray. (Oil not included)
WARNING: DO NOT add oils or other additives
directly into the water tank. Add only to the pad
in the tray. Oils added to the tank will damage the
tank and the whole unit. Any use of such additives
in the tank will void the manufacturers warranty.
Pureguardian essential oils and replacement pads
sold separately at www.guardiantechnologies.com
DIRECTIONS FOR USE
POWER
POWER BUTTON
Before turning on make sure there is water
in the unit. Press the Power Button.
CONTROL OPERATION
NOTE: If control panel lights are off - push any button to wake up, then proceed with control operation below.
1. Night Light Feature
Press the Night Lamp button
to turn night light on/off.
L M H
3. Mist Control Button
When you press the Mist Control
button there are three options:
Press once for LOW
Press twice for MEDIUM*
Press three times for HIGH
*Medium is default setting.
NOTE: The humidifier is equipped with a safety device that will automatically shut the unit off
when activated. To restart, unplug for 5 seconds, replug then press the power button. If the unit
continues to shut down, there may still be an abnormal condition and the unit may need service.
Call Customer Service..
WARM
Warm Humidification Control
Press to select warm mist. When warm
is selected, LED will light. Water temperature is
maintained at room temperature for cool setting
and 80 degrees for warm. Allow 15 minutes for
water to warm.
4 8 12
2. Timer
Press the Timer button to select either 4, 8,
or 12 hours. The unit will turn off in that time.
REFILL
4. Water Refill Indicator
When the unit is low on water the Refill
LED on the front panel will light up, and
the unit will shut off. Simply add more
water to continue use. Unit will
automatically resume running when
water tank has been refilled.
E-7