D-Link DCS-2100+ Quick Installation Manual page 4

Configuring your camera with IP
Installer (continued)
This is the first screen that will appear.
If the IP installer does not display any
devices, lightly insert a paper clip into the
reset opening on the unit's rear panel until
the light starts to cycle (a series of blinks)
twice, then let go.
The IP Installer will now show a MAC
address of the DCS-2100+ and an
IP Address (which may or may not be
correct depending on what you have
your DCS-2100+ connected to.)
If you have a DHCP* server on your
network, a valid IP Address will be
displayed here.
* A DHCP server is a device that
supplies IP Addresses to its
clients that are on the same network.
4