D-Link DCS-2100+ Quick Installation Manual page 3

Hardware Installation (continued)
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the Internet Camera's back panel
(labeled DC 12V) and connect it to an AC power outlet.
When you have a proper connection, the LED (Light Emitting Diode) on the front of the
camera will turn from red to green. The light may blink on and off and your computer may
show an intermittant loss of connectivity if you have it directly connected to the camera.
This is normal until you have configured your camera.
Power source is confirmed when the LED Power Indicator on the Internet
Camera is illuminated.
Configuring your camera with IP
Installer
Insert the DCS-2100+ CD into the
CD-ROM drive.
Click on Install Software
Click on IP Installer
3