Zhone SkyZhone 1600 Installation Manual page 4

____________________________________________________________
4
SkyZhone 1600, 1400, 1200 Hardware Install Guide
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which the user
will be required to correct the interference at their own expense.
•
The supplied cables and antennae must be used to ensure compliance with
Part 15, FCC Rules. The use of any other antennas will invalidate the unit's
FCC Part 15 certification.
•
The 2.4 GHz band has been designed to operate with the antennae listed
below, and having a maximum gain of 5 dBi. Antennae not included in this
list (Comet Part Number CFA-245W-SR) or having a gain greater than 5
dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
•
The 4.9 GHz band has been designed to operate with the antennae listed
below, and having a maximum gain of 5.3 dBi. Antennae not included in
this list (Comet Part Number SF-D49NW-SR) or having a gain greater than
5.3 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms
•
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropic radiated power
(e.i.r.p.) is not more than that permitted for successful communication.
Operating the device with the supplied antennas will ensure that this
requirement is met.
•
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.