Electrolux EHGL3DEEV User Manual page 30

30 www.electrolux.com
11.1 What to do if...
Problem
The cooking zones do not
operate.
You cannot activate or op-
erate the oven. The display
shows "400" and an acous-
tic signal sounds.
The oven does not heat up. The oven is deactivated.
The oven does not heat up. The clock is not set.
The oven does not heat up. The necessary settings are
The oven does not heat up. The fuse is blown.
The lamp does not operate. The lamp is defective.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00". There was a power cut.
There is no good cooking
performance using the Ba-
kingPlus function.
There is no good cooking
performance using the Ba-
kingPlus function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
Possible cause
Refer to the operating instructions for the built-in cooking
surface.
The oven is incorrectly con-
nected to an electrical sup-
ply.
not set.
You left the dish in the oven
for too long.
You did not activate the Ba-
kingPlus function.
You did not fill the cavity
embossment with water.
The temperature is too low. Set the temperature at least
There is too much water in
the cavity embossment.
Remedy
Check if the oven is correct-
ly connected to the electri-
cal supply (refer to the con-
nection diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Reset the clock.
Refer to "Activating the Ba-
kingPlus function".
Refer to "Activating the Ba-
kingPlus function".
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appli-
ance is cold. Wipe the wa-
ter with a cloth or sponge.
Add the correct amount of
water to the cavity emboss-
ment. Refer to the specific
procedure.