Mercedes-Benz GLS Operator's Manual page 93

Vehicles with KEYLESS-GO:
Release the sensor surfaces on the exterior
R
door handle to interrupt the closing proce-
dure.
To open, pull the same door handle immedi-
R
ately and hold it firmly. The door windows and
the sliding sunroof will open for as long as the
door handle is held but the door is not
opened.
Notes on the automatic reversing feature for:
the side window (
R
Y
the sliding sunroof (
R
the panorama roof with power tilt/sliding
R
panel ( page 93)
Y
Using the SmartKey
The SmartKey must be close to the vehicle. For
vehicles without KEYLESS-GO, the SmartKey
must be near the driver's door handle.
Vehicles without KEYLESS-GO: point the tip
X
of the SmartKey at the door handle on the
driver's door.
Press and hold the & button until the side
X
windows and the sliding sunroof or the pano-
rama roof with power tilt/sliding panel are
fully closed.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with power
tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Press and hold the & button again until the
X
roller sunblinds of the panorama roof with
power tilt/sliding panel close.
To interrupt convenience closing: release
X
the & button.
page 89)
page 93)
Y
Using KEYLESS-GO
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
i
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with power
tilt/sliding panel are closed.
Vehicles with a panorama roof with
X
power tilt/sliding panel: touch recessed
sensor surface : on the door handle again
until the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 89).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
Side windows
page 89).
Z
91