Mercedes-Benz GLS Operator's Manual page 210

Hide thumbs Also See for GLS:
Table of Contents

Advertisement

Driving systems
208
The attention level evaluation is deleted and
restarts when the journey is continued, if:
you switch off the engine
R
you take off your seat belt and open the driv-
R
er's door, e.g. for a change of drivers or to
take a break
Displaying the attention level
You can have current status information dis-
played in the assistance menu (
the on-board computer.
Select the Assistance display for ATTENTION
X
ASSIST using the on-board computer
(
page 241).
Y
The following information is displayed:
the length of the journey since the last break.
R
the attention level determined by ATTENTION
R
ASSIST, displayed in a bar display in five levels
from high to low.
If ATTENTION ASSIST is unable to calculate
R
the attention level and cannot output a warn-
ing, the
System suspended
appears. The bar display then changes the
display, e.g. if you are driving at a speed below
37 mph (60 km/h) or above 125 mph
(200 km/h).
Activating ATTENTION ASSIST
Activate ATTENTION ASSIST using the on-
X
board computer (
The system determines the attention level of
the driver depending on the setting selected:
Standard selected: the sensitivity with which
the system determines the attention level is set
to normal.
Sensitive selected: the sensitivity is set higher.
The attention level detected by Attention Assist
page 241) of
Y
message
page 242).
Y
is adapted accordingly and the driver is warned
earlier.
When ATTENTION ASSIST is deactivated, the
À symbol and OFF appear in the multifunc-
tion display in the assistance display when the
engine is running.
When ATTENTION ASSIST has been deactivated,
it is automatically reactivated after the engine
has been stopped. The sensitivity selected cor-
responds to the last selection activated (stand-
ard/sensitive).
Warning in the multifunction display
If fatigue or increasing lapses in concentration
are detected, a warning appears in the multi-
function display:
Attention Assist: Take a
Break!
In addition to the message shown in the multi-
function display, you will then hear a warning
tone.
If necessary, take a break.
X
Confirm the message by pressing the a
X
button on the steering wheel.
On long journeys, take regular breaks in good
time to allow yourself to rest. If you do not take
a break, you will be warned again after
15 minutes at the earliest. This will only happen
if ATTENTION ASSIST still detects typical indi-
cators of fatigue or increasing lapses in concen-
tration.
Vehicles with COMAND: if a warning is issued
in the multifunction display, a service station
search is performed in COMAND. You can select
a service station and navigation to this service
station will then begin. This function can be acti-
vated and deactivated in COMAND.
Traffic Sign Assist
General notes
Traffic Sign Assist displays the maximum speed
permitted to the driver in the instrument cluster.
The data stored in the navigation system and
general traffic regulations are used to determine
the current speed limit.
As Traffic Sign Assist is a map-based system,
traffic signs put up temporarily (e.g. near road-
works) are not detected.

Advertisement

Table of Contents
loading

Table of Contents