JVC KD-SHX705 Service Manual page 12

3.2 CD mechanism assembly
• Prior to performing the following procedure "Removing the CD mechanism assembly".
3.2.1 Removing the front-end board
(See Fig.1)
(1) From the top side of the CD mechanism assembly, solder
the short-circuit point on the flexible wire extending from
the CD pickup.
Caution:
Solder the short-circuit points on the flexible wire extend-
ing from the DVD pickup. If you do not follow this instruc-
tion, the DVD pickup may be damaged.
(2) Disconnect the flexible wire from connector
front-end board.
(3) Disconnect the flexible wire from connector
front-end board.
(4) Remove the solders from two solder points a on the front-
end board and disconnect the wire extending from the feed
motor.
(5) Remove the solders from six solder points b on the front-
end board disconnect the wires extending from the spindle
motor, SW board and reset SW board.
(6) Remove the five screws A attaching the front-end board.
Caution:
Unsolder the solders from the short-circuit points after reas-
sembling.
1-12 (No.MA048)
Flexible wire
CN601
CN601 on the
CN503 on the
Short-circuit point Feed motor
A
A
Front end board
Spindle motor
Fig.1
A
Solder
point a
Solder
point b
CN503
A