Table of Contents
Advertisement
Firepower 7000 Series Devices
Table 2-28
Status
Top (activity)
Bottom (link)
Use the following table to understand the specifications of the SFP optical transceivers.
Table 2-29
Firepower 7115, 7125, and AMP7150 SFP Optical Parameters
Parameter
Optical connectors
Bit rate
Baud rate/encoding/tolerance
Optical interface
Operating distances
Transmitter wavelength
Maximum average launch power
Minimum average launch power
Maximum average power at receiver
Receiver sensitivity
Firepower 7115, 7125, and AMP7150 Chassis Rear View
The rear of the chassis contains the management interface, connection ports, grounding studs, and power
supplies.
Figure 2-15
The following table describes the features that appear on the rear of the appliance.
Firepower 7000 Series Hardware Installation Guide
2 -18
Firepower 7115, 7125, and AMP7150 SFP Socket Activity/Link LEDs
Description
For an inline interface: the light is on when the interface has activity. If dark,
there is no activity.
For a passive interface: the light is non-functional.
For an inline or passive interface: the light is on when the interface has link.
If dark, there is no link.
1000BASE-SX
LC duplex
1000Mbps
1250Mbps
8b/10b encoding
Multimode
656 ft (200 m) for
62.5 µm/125 µm fiber
1640 ft (500 m) for
50 µm/125 µm fiber
770-860 nm
(850 nm typical)
0 dBm
-9.5 dBm
0 dBm
-17 dBm
Firepower 7115, 7125, and AMP7150 (Chassis: GERY-1U-8-4C8S-AC) Rear View
Chapter 2
Hardware Specifications
1000BASE-LX
LC duplex
1000Mbps
1250Mbps
8b/10b encoding
Single mode only
6.2 miles (10 km) for
9 µm/125 µm fiber
1270-1355 nm
(1310 nm typical)
-3 dBm
-11.5 dBm
-3 dBm
-19 dBm
Advertisement
Table of Contents
