Gravely 992261 Owner's/Operator's Manual page 37

1. Lowest Cutting Height
2. Highest Cutting Height
Figure 29
Deck Lift Pedal Adjustment
(Figure 30)
To adjust the foot pedal:
1. Remove the hex bolt securing the foot
pedal to the lift arm.
2. Move foot pedal to desired position.
3. Install hex bolt and torque to 52 – 70 lbf-
ft (71 – 95 N•m).
1
1. Deck Lift Pedal
2. Hex Bolt
Figure 30
Removing the Mower Deck
(Figure 31)
1. Remove PTO belt (See Replacing
Mower Belts on page 34).
WARNING: AVOID INJURY.
Mower lift arms and mower lift
pedal could cause severe injury if
the lift assist spring is not
disconnected before
disconnecting the lift links.
Springs store energy. Keep body
parts well away from pinch points
when removing the deck.
1
2
2
EN - 37
NOTICE: Support the mower deck on blocks
or jack stands before disconnecting links from
mower lift arms to prevent the deck from
falling.
2. Raise the deck to the transport position
and disconnect the lift assist springs (6)
from the mower lift arms (1) on each
side of the deck.
3. Slowly lower the deck to its lowest
position.
4. Remove hardware (5) retaining mower
lift links (2) from mower lift arms.
5. Remove the rear mower mounting pins
(4) connecting the mower mounting
arms (3) to the deck.
6. Slide mower deck out from under unit.
3
1. Mower Lift Arm
2. Mower Lift Link
3. Mower Mounting Arm
4. Mower Mounting Pin
5. Mounting Hardware
6. Lift Assist Spring
Figure 31
Installing the Mower Deck
(Figure 31)
1. Slide mower deck under unit.
2. Connect rear mower mounting arms to
deck with mower mounting pins.
2
6
5
4
1