Gravely 992261 Owner's/Operator's Manual page 30

3
1. Negative Terminal
2. Positive Terminal
3. Battery
4. Hold Down Bracket
Figure 16
1. Remove battery from unit.
2. Clean terminals and battery cable ends
with wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Replace battery.
Battery Electrolyte First Aid
Follow First Aid directions for contact with
battery fluid.
• External Contact: Flush with water.
• Eyes: Flush with water for at least 15
minutes and get medical attention
immediately!
• Internal Contact: Drink large quantities
of water. Follow with milk of magnesia,
beaten egg or vegetable oil. Get
medical attention immediately!
In case of internal contact, DO NOT induce
vomiting!
Charging the Battery
IMPORTANT: DO NOT fast charge. Charging
at a higher rate will damage or destroy
battery. ONLY use an automatic charger
designed for use with your battery.
ALWAYS follow information provided on
battery by battery manufacturer. Contact
battery manufacturer for extensive
instructions to charge battery.
4
2
1. Remove battery from unit. See Remove
Battery on page 29.
2. Place battery on bench or other well-
ventilated place.
3. Connect positive (+) lead of charger to
positive (+) terminal, and negative (–)
lead to negative (–) terminal.
4. Charge battery according to charger and
battery manufacturers' instructions.
5. Replace battery. See Replace Battery on
page 29.
Jump-Starting
Gravely does not recommend jump-starting
your unit. Jump-starting can damage engine
and electrical system components. See your
engine manual for more detailed information.
1
ELECTRICAL SERVICE
Replacing Fuses
IMPORTANT: AVOID DAMAGE! When
replacing fuses use only replacements with
the same amperage rating or you may
damage the circuit.
Replacing Relays
NOTICE: Relays are interchangeable. Use
only quality replacement relays (see Service
Parts on page 42).
1. Remove defective relay from socket.
2. Install new relay into socket.
STEERING CONTROL NEUTRAL
ADJUSTMENT
Eliminating Excessive Creeping of
the Unit
(Figure 17)
1. If hydraulic system is cold, run unit for a
minimum of five minutes, then shut off
engine.
2. With the unit up to and facing a wall, lift
the unit so that both drive wheels are off
the ground.
3. Remove the drive wheels from the unit.
4. Start the engine, run engine at full
throttle, and release the parking brake.
EN - 30
WARNING: This adjustment
requires operating the engine.
Use extreme care to avoid
contact with moving parts and hot
surfaces. Be sure rear of unit is
well supported and secure before
starting engine.