JVC UX-A52 Service Manual page 13

Removing the door switch board
Prior to performing the following procedure, remove
the relay board.
1. Loosen the screw S attaching the door switch.
2. Remove the door switch board while releasing it from
the joint e.
CAUTION: When reattaching the door switch board,
fit it to the joint e
operating state of the switch before
tightening the screw S.
Removing the LCD section
Prior to performing the following procedure, remove
the relay board.
1. Loosen the two screws T attaching the lock lever.
2. Push the part f of the lock lever in the direction of
the arrow as shown in Fig.30-1 / 30-2 and disengage
the LCD section from the front panel assembly.
CAUTION: Because the LCD may come off, hold it
when loosening the screws T.
Lock lever f
Fig.30-1
(See Fig.27 and 28)
and check the
(See Fig.29 to 31)
Lock lever f
Fig.30-2
Drive motor assembly
Fig.27
S
Door switch board
Switch section
Fig.28
Lock lever
T
Front panel assembly
Fig.29
Front panel assembly
LCD section
Joint f
Fig.31
UX-A52
S
Door switch board
Joint e
Joint e
Lock lever
T
Joint f
1-13