JVC UX-A52 Service Manual page 10

UX-A52
Removing the AC jack board
Prior to performing the following procedure, remove
the rear cover, the side panels, the top panel, the
cassette mechanism assembly section, the system
control board and the main board / the tuner board.
1. Disconnect the wire from connector CN809 on the
AC jack board.
2. Remove the screw J and screw K attaching the AC
jack board.
Removing the
assembly (See Fig.20)
Prior to performing the following procedure, remove
the rear cover, the side panels, the top panel, the
cassette mechanism assembly section, the system
control board and the main board.
1. Disconnect the wire from connector CN809 on the
AC jack board.
2. Cut off the band setting the wire on the CD
mechanism cover.
3. Remove the four screws L
transformer assembly.
1-10
(See Fig.18 and 19)
power transformer
attaching the power
Power transformer assembly
J
K
Power transformer
assembly
L
Fig.20
AC jack board
CN809
Fig.18
CN809
AC jack board
Fig.19
L
AC jack board
CN809
Band