Table of Contents
Advertisement
6. To check if the ONIE image is successfully installed on the switch, use the
following command:
© Copyright Lenovo 2017
Following is an example using the cp tftp command:
NE1032T# cp tftp tftp://10.72.97.98/onie/NE1032T-CNOS-10.4.2.0_ONIE.imgs
system-image onie vrf management
Confirm download operation? (y/n) [n] y
Download in progress
...
Copy Success
Install image...This takes about 90 seconds. Please wait
Valid image detected.
Check image signature succeeded
Extracting image: 100%
Installing ONIE:
Updating flash: 100%
Updating ONIE eeprom with manufacturing fields...
ONIE image installation succeeded.
ONIE image now contains Software Version 10.4.2.0
NE1032T# display boot
Current FLASH software:
active image: version 10.4.2.0
standby image: empty
Uboot: version 10.4.2.0
ONIE: version 10.4.2.0
Currently set to boot software active image
Currently scheduled reboot time: none
Current port mode: default mode
In the command output, the current ONIE image installed on the switch is
displayed under the Current FLASH software section.
15
ONIE on the NE1032T
Advertisement
Table of Contents
