Tools (Trampoline); Parts List (Trampoline); Tools (Safety Enclosure) - AlleyOOP Sports 12ft VariableBounce Trampoline System User Manual

Tools (Trampoline)

No tools are required for installation of the trampoline. However, safety glasses and gloves are recommended for safety.

Parts List (Trampoline)

Your 12ft VariableBounce Trampoline System is shipped with the parts shown below. The trampoline parts ship in 2
separate boxes which may arrive on different days. If any parts are missing, immediately call AlleyOOP Sports Custom-
er Service at 408-213-2551.
Reference #
1 LEG-A-11176-01
2 LEG-P-10043-01
3 RAI-P-11175A
4 RAI-P-11174A
MAT-S-11288-01 or
5 MAT-S-11289-01
6 SPR-P-10059A
7a PAD-A-11187A
7b PAD-P-10943A

Tools (Safety Enclosure)

Installation of the safety enclosure requires a 13mm hex wrench and a 5mm Allen wrench, both of which are included in
the safety enclosure box (see Reference #17 and #18). An 8 foot A-Frame ladder will be useful for some steps (use care
and follow procedures for use). Safety glasses and gloves are also recommended for safety.
Parts List (Safety Enclosure)
Your 12ft VariableBounce Trampoline System is shipped with the parts shown below. The safety enclosure parts ship in
a separate box, which has a smaller box inside of it. If any parts are missing, immediately call AlleyOOP Sports Custom-
er Service at 408-213-2551.
Note: Do NOT discard the foam tubing (Reference #12 and #13); it is needed to make the pole assemblies. It is not
just packing material. Do NOT remove any caps from the ends of any of the support poles.
Reference #
10
11
12
13
14
15
16a
16b
16c
16d
16e
17
18
19
20
21
Part #
Horizontal leg piece
Vertical leg piece
Rail piece with 2 leg sockets, 11 spring notches
Rail piece with no leg sockets, 11 spring notches
Mat, 88 V-rings
Spring, 8.5 inches
Frame pad section
Pad connector, with Velcro (connects frame pad sections)
Part #
POL-A-10239A Lower support pole, with snap-button
POL-P-10076A Upper support pole, notch at one end
FOA-P-10078A Long foam tubing (1 tube packed over 1 pole)
FOA-P-10103A Short foam tubing (2 tubes packed over 1 pole)
SLE-P-11398A Pole sleeve, green vinyl
CAP-P-10075A Ball end cap
BOL-P-10081A M8 bolt, Allen head
SPA-P-10083A Pole spacer, black
WAS-P-10082A Washer
NUT-P-10084A M8 Nylock nut
NUT-P-10622A M8 acorn nut, capped end
TOO-P-10158A Wrench, 13mm hex
TOO-P-10159A Wrench, 5mm Allen
NET-P-21208-00 39.4ft x 6ft heavy-duty net
STR-P-11150A 30" Strap with buckle
PLC-P-10132F Warning placard
Nylock nut (Ref. #16d)
Assembly and Installation Instructions
Description
Description
8
Quantity
4
8
4
4
1
88
8
16
Quantity
8
8
8
8
8
8
16
16
32
16
16
1
1
1
8
1
Acorn nut (Ref. #16e)