Extreme Networks AP-8533 Installation Manual page 22

The LEDs display error conditions, and transmission, and network activity for the 5 GHz
802.11ac (amber) radio and the 2.4 GHz 802.11n (green) radio, sensor radio (white) and the
BLE radio (blue).
State
Firmware
Update
Normal
Operation
Not
configured
Locate AP
Mode
Sensor
without
SS
connected
Sensor with
SS
connected
Air
Termination
state
BT radio
disabled
BT radio
enabled
(operational)
AP-8533 Access Point Installation Guide
2.4 GHz
5 GHz Activity Activity LED
LED (Amber) (Green)
On Off
If the radio for If the radio for
this is disabled: this is disabled:
turned off. turned off.
If there is If there is
activity on this activity on this
band: band:
Blink interval at Blink interval at
2 times per 2 times per
second second
On On
LEDs blink in an LEDs blink in an
alternating alternating
green, amber, green, amber,
blue and white blue and white
pattern using an pattern using an
irregular blink irregular blink
rate. This LED rate. This LED
state in no way state in no way
resembles resembles
normal normal
operating operating
conditions conditions.
N/A N/A
N/A N/A
N/A N/A
N/A N/A
N/A N/A
Hardware Installation
LED (Blue) LED (White)
Off Off
N/A N/A
N/A N/A
LEDs blink in an LEDs blink in an
alternating alternating
green, amber, green, amber,
blue and white blue and white
pattern using an pattern using an
irregular blink irregular blink
rate. This LED rate. This LED
state in no way state in no way
resembles resembles
normal normal
operating operating
conditions. conditions
N/A Off
N/A On
N/A Blinking 0.5
second in 1
second duty
cycle
Off N/A
On N/A
20