Hardware Installation; Installation Instructions; Precautions - Extreme Networks AP-8533 Installation Manual

Hide thumbs Also See for AP-8533:

Regulatory manual (13 pages)

Table Of Contents

Table of Contents

Installation Instructions

An AP-8533 Access Point mounts either on a wall (with M 3.5 x 0.6 x 23 MM pan head

screws and mounting bracket or equivalent) or on a suspended ceiling T-bar.

To prepare for the installation:

1 Match the part number on the purchase order with the part numbers in the packing list

and on the case of the Access Point.

2 Verify the contents of the box include the intended AP-8533 Access Point, and the

included hardware matches the package contents (see

page 4

)

Part Number

AP-8533-68SB30-US

AP-8533-68SB30-1-WR

AP-8533-68SB40-US

AP-8533-68SB40-1-WR

3 Review site survey and network analysis reports to determine the location and mounting

position for the AP-8533 Access Point.

4 Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or 802.3af power

source and run the cable to the installation site. Ensure there is sufficient slack on the

cable to perform the installation steps.

Note

When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6 cable is

recommended for Gigabit operation.

Precautions

Before installing an AP-8533 Access Point, verify the following:

• You are using the correctly rated power solution for the AP-8533 (either the AP-PSBIAS-

2P3-ATR Power Injector or the PWR-BGA48V45W0WW external power supply)

• Do not to install the AP-8533 in wet or dusty areas.

AP-8533 Access Point Installation Guide