Extreme Networks AP-7532 Installation Manual page 16

i Attach the power adapter cable into the power connector on the Access Point.
j Attach the power supply line cord to a power supply.
CAUTION
If not using an AP-PSBIAS-2P3-ATR power injector, ensure only the AP-7532's
designated power supply (PWRS-14000-54R) is used to supply power to the Access
Point. Using an incorrectly rated power supply could damage the Access Point and
void the product warranty. Do not actually connect to the power source until the
cabling portion of the installation is complete..
3 Verify the unit has power by observing the LEDs. For more information on AP-7532 LED
behavior, see "LED Indicator" on page 15.
4 Align the bottom of the ceiling T-bar with the back of the Access Point.
5 Orient the Access Point chassis by its length and the length of the ceiling T-bar.
6 Rotate the Access Point chassis 45 degrees clockwise.
7 Push the back of the Access Point chassis on to the bottom of the ceiling T-bar.
8 Rotate the Access Point chassis 45 degrees counter-clockwise. The clips click as they
fasten to the T-bar.
AP-7532 Access Point Installation Guide
Hardware Installation
14