Extreme Networks AP-7532 Installation Manual page 11

The Access Point Power Supply (Part No. PWRS-14000-54R) is not included with the
Access Point, but it can be ordered separately as an accessory. If the Access Point is
provided both POE power and PWRS-14000-54R power concurrently, the Access Point will
source power from the PWRS-14000-54R supply only. Disconnecting the AC power from
the PWRS-14000-54R causes the Access Point to re-boot before sourcing power from the
POE power injector. If the AP is operating using injector supplied power, the AP will not
automatically reboot if an AC adapter is connected. The Access Point continues to operate
with power supplied from the AC adapter without change to the Access Point operating
configuration. If using AC adapter supplied power and a change to the AP's operating
configuration is warranted, the Access Point needs to be manually rebooted by the
customer.
CAUTION
The Access Point supports any standards-based compliant power source. However,
using the wrong solution (including a POE system used on a legacy Access Point)
could either limit functionality or severely damage the Access Point and void the
product warranty..
A separate Power Injector is required for each AP-7532 Access Point comprising the
network.
The Power Injector can be installed free standing, on an even horizontal surface or wall
mounted using the power injector's wall mounting key holes.
AP-7532 Access Point Installation Guide
Hardware Installation
9