D-Link DCS-4622 User Manual page 10

Section 2: Installation
Use an Ethernet cable to connect the camera's Ethernet jack to your PoE switch
or injector. If you are not using PoE to power the camera, you may connect a 12 V
1.5 A power adapter to the power connector.
Attach the camera mount to the mounting plate.
If you are running the camera cables out the side of the camera, guide the
camera cables through the cable channel on the camera mount.
If you wish to run the camera cables through the wall or ceiling, pull the
cables through the hole.
D-Link DCS-4622 User Manual 10