Advertisement
Assembly
7.
7. a) Attach the middle handlebar (6) to the upright post (33)
as shown in FIG.7.
b) There is a rubber bung situated at the right handside of
the upright. Take this off and attach it to the handlebar cables
and feed the wires through the hole ensuring that the rubber
bung is placed back in the hole. There should now be three
cables coming out of the upright stem.
c) Insert and tighten the bolt (11), the handlebar plastic cover
(12) and the arc washer (10).
9.
9. Attach the handlebar cover (15AB/27AB) to lower
handlebar tube (26LR) with bolt (14).
b) Attach rubber nut covers 66 (small) to the back of the
lower pedal tube to cover the exposed bolt head. Add nut
cover 63 (large) to the inner left and right pedal arms at rear.
c) Attach the pedal tube cover (48/49) to lower handlebar
tube (26L/R) with bolt (47).
12
8.
8. Connect hand pulse cables, then connect sensor cable (13)
to the computer (1); fix the computer (1) onto the upright
post (33) with screw (28). When you want to use the cross
trainer, insert the power adapter (50) into a power socket, and
insert the jack into the machine socket located at the rear.
Be sure that the console and machine works properly before
going to step 9.
CAUTION: Make sure you have tightened all the bolts and
nuts well before beginning your workout.
NOTE: The front stabiliser is fitted with wheels to allow easy
transportation of this machine.
Advertisement
