At The End Of The Program; When The Washing Program Is Completed, But There Is Water In The Drum; Auto Standby Function - Electrolux EWF14933 User Manual

5.9 At The End Of The Program

-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator "
-
Remove the laundry from the
appliance. Make sure that the drum is
empty.
-
Keep the door ajar, to prevent the
mildew and odours.
-
Turn off the water tap.
At the end of the program the time
remaining can suddenly decrease
from 7 minutes or less to 0 due to the
overestimated total program time
during the load sensing phase. In
some cases (with perfectly balanced
load) the program time can be shorter
than the time estimated after the load
sensing phase is completed. This is a
normal behavior of the machine and
not a cause for concern as it does not
compromise its performance.
5.10 When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold" or "Extra
Silent" is used)
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause" flashes to
remind you to drain the water.
-
The door lock indicator "
The door stays locked.
You must drain the water to open the
door.
To drain the water:
Press the "Start/Pause
1.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
".
2.
" goes off.
3.
5.11
The AUTO Standby mode automatically
deactivates the appliance to decrease the
energy consumption when:
You do not press any buttons for 5
minutes before you press "Start/Pause".
-
-
5 minutes after the washing program
ends, if you do not deactivate the
appliance, the energy saving function
activates.
" is on.
-
-
" touchpad.
-
-
-
Alternatively, before pressing the
"Start/Pause" touchpad, you can press
the "Spin " touchpad to change the
spin speed. You can select "No Spin",
if you want the machine to only drain
the water.
When the program is completed and
the door lock indicator "
you can open the door.
turn the program selector knob to the
position "Off" to deactivate the
appliance.
NOTE:
After approximately 18 hours if you do
not press Start/Pause touchpad, the
appliance will drain and spin
automatically (except for "Wool"
program) .

AUTO Standby Function

All indicators and the display will
switch off.
The indicator of the touchpad
Start/Pause will flash slowly.
Press any touchpad to reactivate
the appliance.
All indicators and the display will
switch off.
The indicator of the touchpad
Start/Pause will flash slowly.
Press any touchpad to reactivate
the appliance.
Display will show the end of the last
wash.
Press any touchpad again to show
the last wash program.
Turn the selector knob to set a new
wash program.
17
" goes off,