Controlling With A Computer - Sharp PN-V701 Operation Manual

6. Click on "LAN SETUP" under NETWORK.
7. Specify the "DHCP CLIENT", "IP ADDRESS",etc.
DHCP CLIENT
If your LAN has a DHCP server and you wish to obtain an
address automatically, change this setting to ON.
To set the address manually, set this to OFF.
IP ADDRESS
If the DHCP CLIENT is set to OFF, specify an IP address.
SUBNET MASK
If the DHCP CLIENT is set to OFF, specify the subnet mask.
DEFAULT GATEWAY
If the DHCP CLIENT is set to OFF, specify the default gateway.
If you are not using a default gateway, specify "0.0.0.0".
8. When the setting is changed, click [Apply].
9. Check the message and click [OK].
10. Exit the web browser.
11. Restore the computer's IP address jotted in Step 6, "(2)
Specifying the computer's IP address".
12. Connect the monitor and the computer to the LAN.
Caution
• Wait 10 seconds after clicking [OK] before proceeding.
• When operating using the remote control unit or similar,
click [Refresh].
TIPS
• When the IP address is set manually, the IP addresses of
the monitor connected to the RS-232C output terminal and
the daisy chain of connected monitors that follows can be
assigned automatically. (See page 29.)
Controlling the Monitor with a computer (LAN)

Controlling with a computer

nBasic operation
You use the web browser on a computer on the LAN to control
the monitor.
1. Launch the web browser on the computer.
2. In the "Address" box, type "http://" followed by your monitor's
IP address followed by "/", then press the Enter key.
You can confirm the IP address with the INFORMATION
function.
When prompted to enter a USER NAME and PASSWORD,
type the user name and password that you specified in the
SECURITY settings (see page 55), and click [OK].
The following values are set in the initial settings.
USER NAME: admin, PASSWORD: admin
* To enable security on the monitor, change the user
name and password. (See page 55.)
3. You can check, control, and change the monitor's status
and settings by clicking the menu items on the left side of
the screen.
• If you see an [Apply] button next to a setting, click it after
you change that setting.
TIPS
• See pages 54 to 58 for details on each setting.
• If you click [Refresh] before the screen finishes updating
the current display, the "Server Busy Error" will appear.
Wait for a moment before operating your monitor again.
• You cannot operate the monitor while it is warming up.
• If DHCP CLIENT is set to ON, check the monitor's IP
address in INFORMATION2. (See page 21.)
53
E