Clevo W241EUQ Service Manual page 36

Disassembly
Processor Installation Procedure
Figure 8
Processor
1. Insert the CPU
Installation
IT!), and turn the release latch
2. Remove the sticker
a. Insert the CPU. 3. Insert the heat sink
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order r
wards the lock symbol.
5. Replace the component bay cover (don't forget to replace the fan cable) and tighten the screws
c. Remove the sticker from
the heat sink and insert
the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 3 Screws
2 - 12 Removing and Installing a Processor
(Figure 8a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
A
towards the lock symbol
B
(Figure 8c) from the heat sink.
C
as indicated in
D
a.
A
b.
B
(Figure 8b).
Figure 8d.
, &
(the order as indicated on the label and
1 2 3
c.
d.
3
D
1
2
Figure 8d).
(page 2 - 14).
C
Note:
Tighten the screws
in the order as indi-
cated on the label.