Led Indicators - Axis M3045-V User Manual

AXIS M3045-V Network Camera
Hardware overview
Control Button
For location of the control button, see Hardware overview on page 7 .
The control button is used for:
• Resetting the product to factory default settings. See page 56.
• Connecting to an AXIS Video Hosting System service. See page 48. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 48. To connect, press and hold the button for about 3 seconds.

LED Indicators

Note
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance.
Status LED
Unlit
Green
Amber
Amber/Red
Red
Note
Amber is a combination of red and green, and can be perceived as either of these colors depending on viewing angle.
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Steady during startup. Flashes during firmware upgrade or reset to factory default.
Flashes amber/red if network connection is unavailable or lost.
Firmware upgrade failure.
8