Table of Contents
Advertisement
As Required
1. Recondition or replace low water cut-off device (if
equipped).
2. Check drip leg and gas strainers.
3. Check flame failure detection system. (See "Post
Start-Up Check" in the I&O Manual.) Verify high
and low fire flame signal, compare to start-up data,
4. Check igniter. Clean and verify spark gap (see Fig.
36 in the I&O Manual) .
5. Check fan speed and manifold pressure. (See
"Blower Check" and "Manifold Check" in the I&O
Manual.)
6. Test safety/safety relief valves in accordance with
ASME Heater and Pressure Vessel Code Section
IV.
www.raypak.com
Raypak, Inc., 2151 Eastman Avenue, Oxnard, CA 93030 (805) 278-5300 Fax (805) 278-5468
Litho in U.S.A.
Advertisement
Table of Contents
