Table of Contents
Advertisement
1. Touch
.
The indicator of this button flashes.
2. Change the options. If you change any option
the Finish In option (if set) will be disabled.
3. Touch
again.
The programme continues.
CANCELLING A PROGRAMME
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
While a programme (or the
appliance door is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
To open the door during the first minutes of
the cycle (or when the
1. Touch the button
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
The programme (or the
AT THE END OF THE PROGRAMME
•
The appliance stops automatically.
•
The acoustic signal operates (if it is activated).
•
In the display
comes on.
•
The indicator of the button
•
The door lock indicator
•
You can open the door.
•
Remove the laundry from the appliance. Make
sure that the drum is empty.
•
Press the button
deactivate the appliance.
•
Close the water tap.
12
for some seconds to
) operates, the
is on.
operates) :
to pause the appliance.
goes off.
) continues.
goes off.
goes off.
for some seconds to
•
Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
The washing programme is completed, but
there is water in the drum:
•
The drum turns regularly to prevent the creases
in the laundry.
•
The indicator
the water.
•
The door lock indicator
of button
•
You must drain the water to open the door.
Draining the water:
1. To drain the water.
•
Touch the button
drains the water and spins with the
maximum spin speed for selected washing
programme.
•
Alternatively, touch the button
the spin speed and then touch the button
. The appliance drains the water and
spins. If you set
drains.
2. When the programme is completed and the
door lock indicator
the door.
3. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
AUTO-OFF OPTION
The AUTO-OFF stand-by option automatically
again.
deactivates the appliance to decrease the energy
consumption. All the indicators and the display go
off when :
•
You do not use the appliance for 5 minutes
before you touch
Press the button
again.
•
After 5 minutes from the end of the washing
programme.
Press the button
again.
The display shows the end of the last set
programme.
Touch the button
cycle.
flashes to remind you to drain
is on. The indicator
flashes. The door stays locked.
. The appliance
, the appliance only
goes off, you can open
for some seconds to
.
to activate the appliance
to activate the appliance
if you want to set a new
to change
Advertisement
Table of Contents
