Table of Contents
Advertisement
B
When you use the liquid detergent:
•
Do not use gelatinous or thick liq-
uid detergents.
•
Do not put more liquid then 120
ml.
•
Do not set the delay start.
A
•
Measure out the detergent and the fabric condi-
tioner.
•
Put the detergent and the fabric conditioner into
the compartments.
•
Carefully close the detergent drawer.
ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the On/Off
button to activate or deactivate the appliance.
A tune sounds when the appliance is activated.
The display shows the word On.
SETTING A PROGRAMME
1. Touch the programme button
programme:
•
The indicator of the button
•
The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
2. Adjust the flap in posi-
tion B.
3. Put back the drawer in
the recess.
When the flap is in posi-
tion B and you want to
use powder detergent:
1. Remove the drawer.
2. Adjust the flap in po-
sition A.
3. Put back the drawer
in the recess.
and set the
flashes.
.
STARTING A PROGRAMME WITHOUT THE
FINISH IN
OPTION
Touch the button
•
The indicator of the button
flash and stays on.
•
The programme starts, the door locks, the
indicator
•
The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
•
The appliance adjusts automatically
the programme duration agree with
the laundry load.
•
The display shows the new value.
STARTING A PROGRAMME WITH THE
FINISH IN OPTION
1. Touch the button
choose the number of hours in which you want
the washing cycle to be finished.
The display shows the number of hours you set
(e.g.
) and the indicator above the button
on to show that his option is active.
2. Touch the button
•
The door is locked.
•
The appliance starts the countdown.
•
When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
button
you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
.
stops to
is on.
again and again to
:
. After touching the
to set the appliance
until the indicator
again to start the
is
11
Advertisement
Table of Contents
