Download Table of Contents Print this page

Possible Failures - Zanussi ZWF 01483W User Manual

Advertisement

Table of Contents

POSSIBLE FAILURES

Problem
The programme does not
start.
The appliance does not fill
with water properly.
The appliance does not
drain the water.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
There is water on the floor.
You cannot open the appli-
ance door.
The appliance makes an
unusual noise.
16
Make sure that the mains plug is connected to the mains socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of
countdown.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is correct.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the connection of the drain hose is correct.
Set the drain option if you set a programme without drain phase.
Set the drain option if you set an option which ends with water in
the drum.
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
Set the spin option.
Set the drain option if you set an option which ends with water in
the drum.
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
If above mentioned solutions do not help, contact the Authorised
Service Centre (as the filter of the drain pump may be clogged).
Make sure that the couplings of the water hoses are tight and there
is not water leakages.
Make sure that the water inlet hose and the drain hose have no
damages.
Make sure you use the correct detergent and the correct quantity of
it.
Make sure that the washing programme is finished.
Set the drain or the spin option if there is water in the drum.
Do the emergency drain procedure. See "Frost precautions" (in
"Care and Cleaning" chapter).
Make sure the levelling of the appliance is correct. Refer to 'Installa-
tion instruction'.
Make sure that the packaging and/or the transit bolts are removed.
Refer to 'Installation instruction'.
Add more laundry in the drum. The load may be too small.
Possible solution

Advertisement

Table of Contents
loading

Table of Contents