Keystone - Eiki EK-103X Owner's Manual

Keystone

This function is used to store or reset the
keystone correction when the AC power cord is
unplugged.
1 Press MENU button on the remote control
to display screen menu. Press  button
to select "Expand", then press the OK button.
2 Press button to select "Keystone", press
the OK button.
3 Press button to select the item you want
to set, press the OK button.
Keystone
Sets whether or not to keep the keystone
correction after turn off the projector or plug out
the power cord.
Store ..... The keystone correction will be kept when plug out the power cord or turn off the
projector.
Reset .... When "Standby mode" is set to "Eco", plug out the power cord or turn off the projector,
the keystone correction will be canceled. When "Standby mode" is set to "Normal", plug
out the power cord, the keystone correction will be canceled; turn off the projector, the
keystone correction will be kept.
V Keystone
Adjust when the vertical trapezoid of the projected image is distorted.
Reduce the upper
width with  button.
 Note:
● The white arrows indicate that there is no correction.
● A red arrow indicates the direction of correction.
● An arrow disappears at the maximum correction.
● Correcting up to ±30° for the tilt in the vertical direction is available for adjustments with "Keystone".
However, the image quality will degrade and it will get harder to focus with more correction.
Install the projector so that the correction will be as small as possible.
● Screen size will also change when "V Keystone" is used to perform various adjustments.
● Aspect ratio of the image size may shift depending on the correction.
38
Expand
Reduce the lower
width with  button.
Keystone menu
Expend
Keystone
Keystone
V Keystone
Store