Replacing The Tail/Brake Light Bulb; Removing A Wheel - Yamaha BIG BEAR 250 YFM25BZ Owner's Manual

EBU25611

Replacing the tail/brake light bulb

If the tail/brake light bulb burns out, replace it as
follows.
1. Remove the bulb holder (together with the
bulb) by turning it counterclockwise.
8
1. Tail/brake light bulb holder
2. Remove the burnt-out bulb by pushing it in
and turning it counterclockwise.
1. Tail/brake light bulb holder
2. Tail/brake light bulb
3. Insert a new bulb into the bulb holder, push it
in, and then turn it clockwise until it stops.
4. Install the bulb holder (together with the bulb)
by turning it clockwise.
EBU25651

Removing a wheel

1. Place the ATV on a level surface.
2. Loosen the wheel nuts.
8-45