Yamaha BIG BEAR 250 YFM25BZ Owner's Manual page 110

1. Locknut
2. Brake pedal position adjusting bolt
3. Brake pedal position
a. Remove the footboard. (See "Engine oil"
8
on page 8-11 for removal and installation
procedures.)
b. Loosen the locknuts at the brake pedal.
c. Turn the brake pedal position adjusting
bolt at the brake pedal in direction (a) to
raise the brake pedal, and in direction (b)
to lower it.
d. Tighten the locknuts at the brake pedal.
2. Adjusting the brake pedal free play
The brake pedal free play should measure
20.0–30.0 mm (0.79–1.18 in) as shown. If the
free play is incorrect, adjust it as follows.
1. Brake pedal free play
a. Fully loosen the brake lever free play ad-
justing nut on the brake cable at the rear
wheel hub.
b. Turn the brake pedal free play adjusting
nut on the brake rod at the rear wheel hub
in direction (a) to increase the free play,
and in direction (b) to decrease it.
8-31