Installing The Chute; Installing The Chute Control Rod - Toro 38811 Operator's Manual

3

Installing the Chute

Parts needed for this procedure:
2 Nut
2 Carriage bolt
2 Flat washer
Procedure
1. Place the chute on the frame and the align the discharge
chute mount to the chute support.
1
1. Carriage bolt
2. Flat washer
2. Secure the discharge chute mount using 2 bolts, 2 nuts,
and 2 flat washers.
3
2
g019379
Figure 8
3. Nut
4
Installing the Chute Control
Rod
Parts needed for this procedure:
2 Carriage bolts
2 Locknuts
Procedure
1. Remove the blue rod cap from the chute control rod.
2. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into the
chute gear (Figure
1. Short rod
3. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose parts bag) through
8
10).
g019005
Figure 9
2. Long chute control rod
g018899
Figure 10