LevelOne WAP-6101 User Manual page 37

Regulatory Domain. The factory default setting is auto channel selection. It's
recommended to choose a channel that is not used in your environment to reduce
radio interference
4. Wireless Mode: The RF1 module supports 802.11b/g/n modes. You can also
choose "N only", "G/N mixed" or "B/G/N mixed". The factory default setting is
"B/G/N mixed".
5. Bandwidth: The default setting for Bandwidth is "Auto". You can change it to
"20MHz" with care if some clients are suffering from the connectivity problem in
higher bandwidth setting.
6. Authentication & Encryption: You may select one of the following
authentications to secure your wireless network: Open (include 802.1x), Shared,
Auto, WPA-PSK, and WPA2-PSK.
 Open
Open system authentication simply consists of two communications. The first
is an authentication request by the client that contains the station ID (typically
the MAC address). This is followed by an authentication response from the AP
containing a success or failure message. An example of when a failure may
occur is if the client's MAC address is explicitly excluded in the AP's
configuration.
In this mode you can also enable the 802.1x feature if you have another
RADIUS server for user authentication. You need to input IP address, port,
shared key of RADIUS server here.
In this mode, you can only choose "None" or "WEP" in the encryption field.
 Shared
Shared key authentication relies on the fact that both stations taking part in the
authentication process have the same "shared" key or passphrase. The
shared key is manually set on both the client station and the AP. Three types
of shared key authentication are available today for home or small office
WLAN environments.
 Auto
The gateway will select appropriate authentication method (Open or Shared)
according to the WiFi client's request automatically.
 WPA-PSK
Select Encryption mode and enter the Pre-share Key. You can fill in 64